Instruction Manual
Tentative
14
FHE: End FH operation
【Format】
FHE
【Response】
P0 : normal termination
N0 : command error
【Function】
・End FH operation. At this status, wireless transmission does not occur.
・Master/Slave stops radio transmission and reception. If state that FH synchronization acquisition,
and then release it.
・Even when there is received data from a paired module, wired output does not occur.
FHS :Starts FH operation
【Format】
FHS
【Response】
P0 : normal termination
N0 : command error
【Function】
・Starts FH operation.
・Master/Slave starts radio transmission and reception.
・When there is received data from a paired master, wired output starts.
・If there is data received from pairing the communication partner, to start the output to the
wired.
ID1 :Reference and set pairing ID1
【Format】
ID2(:pairing ID code 1)
pairing ID code 1 : xxxxxxxxx(9-digit)
【Response】
xxxxxxxxx : pairing ID code 1 (when when referencing)
P0 : normal termination (when setting)
N0 : command error
【Function】
・References and sets the pairing ID code 1.
・By inputting only the command, currently set values can be referenced.
・Specify the ID code (9-digit Serial Number) of the module that is the communication partner.
・Both master and slave are valid.
・The setting becomes effective after a reset.