Instruction Manual

Tentative

ＦＨＥ: End FH operation

【Format】

FHE

【Response】

P0 : normal termination

N0 : command error

【Function】

・End FH operation. At this status, wireless transmission does not occur.

・Master/Slave stops radio transmission and reception. If state that FH synchronization acquisition,

and then release it.

・Even when there is received data from a paired module, wired output does not occur.

ＦＨＳ：Starts FH operation

【Format】

FHS

【Response】

P0 : normal termination

N0 : command error

【Function】

・Starts FH operation.

・Master/Slave starts radio transmission and reception.

・When there is received data from a paired master, wired output starts.

・If there is data received from pairing the communication partner, to start the output to the

wired.

ＩＤ１：Reference and set pairing ID1

【Format】

ID2(:pairing ID code 1)

pairing ID code 1 : xxxxxxxxx（9-digit）

【Response】

xxxxxxxxx : pairing ID code 1 (when when referencing)

P0 : normal termination (when setting)

N0 : command error

【Function】

・References and sets the pairing ID code 1.

・By inputting only the command, currently set values can be referenced.

・Specify the ID code (9-digit Serial Number) of the module that is the communication partner.

・Both master and slave are valid.

・The setting becomes effective after a reset.