Instruction Manual

Tentative
16
ＯＤＡ ：Disable output
【Format】
ODA
【Response】
P0 ：normal termination
N0 ：command error
【Function】
・Disable the radio transmission and wired output. Temporarily used when you want to stop FH
communication. If this module already has FH synchronization acquisition, also it will continue
to maintain FH synchronization after executing this command.
・Output in the initial state is enabled.
・Slave only.
ＯＥＮ ：Enable output
【Format】
OEN
【Response】
P0 ：normal termination
N0 ：command error
【Function】
・Enable the radio transmission and wired output.
・Output in the initial state is enabled.
・Slave only.
ＲＥＧ ：Reference and set register values
【Format】
REG[register number](:set value)
Register number : 00～XX
Set value : input a two-digit hexadecimal number with H at the end,
or a three-digit decimal number without any suffix.
【Response】
XXX : currently set value (when referencing)
P0 : normal termination (when setting)
N0 : command error
N6 : memory register writing error
【Function】
・References and sets the memory register.
・By inputting only a register number, currently set values can be referenced.
・The setting will be valid after reset.