Instruction Manual

Tentative
19
7.2 Memory register function detail
ＲＥＧ００：Operation mode ［default：００Ｈ］
* Sets an operation mode (for the master or the slave).
Table 5：Operation mode
00H
Master (default)
01H
Slave
ＲＥＧ０１：Reserved ［default：００Ｈ］
* Not used in this wireless module. Leave default setting.
ＲＥＧ０２：Frequency hopping pattern ［default：００Ｈ］
* Sets the frequency hopping pattern. It can be set to 00～1E (0～30).
* Master only settings are valid. Slave sets the frequency hopping pattern automatically based
on the information of the master.
* In the initial state, a specific frequency hopping pattern is set. Because it is set to 00H
if you initialize, please set again.
* When using multiple systems within the same area, the frequency may periodically match and
interfere with each other even when the frequency hopping patterns are different.
ＲＥＧ０３：Reserved ［default：００Ｈ］
* Not used in this wireless module. Leave default setting.
ＲＥＧ０４：Wireless communication setting 1 ［default：０８Ｈ］
Bit7～4：Reserved
* Not used in this machine. Make sure to set to 0.
Bit3：Antenna diversity
Table 6：Antenna diversity
0
Disable antenna diversity
1
Enable antenna diversity （default）
* Enables/disables antenna diversity.
* When used with two antennas, set to 1 in this bit.
Bit2：Antenna selection
Table 7：Antenna selection
0
Antenna is fixed to A （default）
1
Antenna is fixed to B
* At the non-diversity reception, decide the antenna terminal.