Instruction Manual

Tentative
21
Bit2～0：Baud rate setting
Table 12：Baud rate
Bit2
Bit1
Bit0
Baud rate
0
0
0
19200bps
0
0
1
115200bps (default)
0
1
0
Reserved
0
1
1
Reserved
1
0
0
Reserved
1
0
1
Reserved
1
1
0
Reserved
1
1
1
Reserved
ＲＥＧ０９：Wired communication setting 2 ［default：００Ｈ］
Bit7～5：Reserved
* Not used in this machine. Make sure to set to 0.
Bit4：Addition and deletion of CRLF
Table 13：Addition and deletion of CRLF
0
Do not add the CR+LF code to the receive data. （default）
1
Add the CR+LF code to the receive data.
* Sets whether adding the CRLF code or not to the received data.
Bit3～0：Reserved
* Not used in this machine. Make sure to set to 0.
ＲＥＧ１０～１１：Reserved ［default：００Ｈ］
* Not used in this wireless module. Leave default setting.
ＲＥＧ１２：Detailed setting ［default：０８Ｈ］
Bit7：Startup message output
Table 14：Startup message output
0
Disable startup message output （default）
1
Enable startup message output
* When you want to output message at startup, set to 1 in this bit.
* At startup, “Input command” is output to the wired. By this message, you can recognize the
activation timing.
Bit6～4：Reserved
* Not used in this machine. Make sure to set to 0.
* No function assignment.