User's Manual

Battery cover
Slide battery cover while pressing here.
16
Before Using
Battery Replacement Method
1
Remove the battery cover from the transmitter
by sliding it in the direction of the arrow in the
figure.
2
Remove the used batteries.
3
Load the new AA size batteries. Pay very close
attention to the polarity markings and reinsert
accordingly.
4
Slide the battery cover back onto the case.
Battery Replacement Method (4 AA Size Batteries)
Load the four batteries in accordance with the po-
larity markings on the battery holder.
Check:
Turn the power switch on the transmitter to the ON position. Check the battery
voltage display on the LCD screen. If the voltage is low, check the batteries for in-
VXI¿FLHQWFRQWDFWLQWKHFDVHRULQFRUUHFWEDWWHU\SRODULW\
Disposal of the Dry Cell Batteries:
The method to dispose of used dry cell batteries depends on the area in which you
reside. Dispose of the batteries in accordance with the regulations for your area.
󾾝
Caution
󾾛
Never try to recharge a dry cell battery.
The transmitter may be damaged or the battery electrolyte may leak or the battery may break.
󾾙
Insert the batteries in the correct polarity.
If the polarity is incorrect, the transmitter may be damaged.
󾾙
When the transmitter is not in use, remove the batteries.
If the battery electrolyte leaks, wipe off the case and contacts.
󾾛
Do not use commercial AA size NiCd and NiMH batteries.
Quick charging may cause the battery contacts to overheat and damage the
battery holder.
4PLS-Eng-04-Before-P12-24.indd 16 2013/04/07 11:35:54