User's Manual

The function select switch
screen (P65) can be dis-
played from this screen.
< NO SW >
If function’s ON/OFF
switch is not selected,
<NO SW> is displayed.
73
Function
4WS Mixes “4WS”
1
(4WS type selection)
Select the setting item "MODE" by the (JOG)
button up or down operation. Use the (+) or
(-) and set the function to the "ON" or "OFF"
state.
"INH" :Function OFF (front only)
"2TYP" :Front side only, reverse phase switching
"3TYP" :Front side only, reverse phase and same phase switching
"4TYP" :Front side only, reverse phase, same phase, and rear side only switching
Switched in the order shown in the figure below by set SW
Function ON/OFF (MODE)
OFF, 2TYP, 3TYP, 4TYP
Mixing mode (MXMD)
OFF, ON
Initial value: OFF
Rear rate (RATE)
0 ~ 100
Initial value:100
"2TYP"
：
Front side only and reverse
phase switching
"3TYP"
：
Front side only, reverse phase, and same phase switching
"4TYP"
：
Front side only, reverse phase, same phase, and rear side only switching
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) but-
tons simultaneously (approx.
1 sec).
2
(Rear side travel adjustment)
Select setting item "RATE" by the (JOG) button up or down
operation. Adjust the rear side travel with the (+) or (-) but-
ton.
3
(Mix mode setting)
Select setting item "MXMD" by the (JOG) button up or down
operation. Set the mix mode with the (+) or (-) button.
"OFF" :The EXP function of the 1st CH and other settings are not mixed.
"ON" :The EXP function o the 1st CH and other settings are mixed.
4
When ending, return to the MENU screen by moving the cur-
sor to the positions other than SW/DIAL and pressing the
(JOG) button.
Select button
- Select with the (+) or (-) but-
tons.
Select button
- Select with the (+) or (-) but-
tons.
4PLS-Eng-08-2-Function-P65-83.indd 73 2013/04/07 12:48:14