User's Manual

Page 92 FRH-SD07TU/TB Manual

PAS nce and Set Repeater Address Refere

Syntax

PAS (Repeater Address)

: command error

nd sets the

This command is used to temporarily change repeater address. To change the

ult value, change REG13.

>@PAS CR/LF : references the current repeater address

<P0 CR/LF : command accepted

sed in 485 mode.

Repeater Address : repeater address to pass through

Response

xxx : current address (reference)

P0 : command accepted (setting)

Function

In the headerless packet transmission mode (mode 5), references a

repeater address to pass through

When no repeater address is set, the current setting can be referenced.

defa

Example

<000 CR/LF : current repeater address is 000

< @PAS002 CR/LF : sets the repeater address to 002

<P0 CR/LF : command accepted

Notes

This command is not allowed to be u

Rev. 050415-01.1