User's Manual

Page 124 FRH-SD07TU/TB Manual
7.1.4 M emory Re g
The basic setup is the
In the headerless packet mode, the following settings should be added.
ist e r Settings
same as that of normal packet transmission mode (mode 3 and 4).
REG02: Destination Address Default value: 00H
Set the address of the modem to transmit data as the destination address. Setting to 000 to
ission data packet to transmit to the destination address.
18) is valid, set the address of the receiving
odem mand can change this destination address.
Default value: F0H
239 is available (240 addresses).
This value is padded to the transm
When address checking function (REG
m to this register. DAS com
REG03: Operation Mode Setting
Set the operation m e to the headerless packe
REG13: Repeater Address Default valu
od t transmission mode (FFH).
e: 1EH
When a repeater is used, set the repeater address to pass through.
REG16: Terminator Setup 1 Default value: 32H
Set an arbitrary 1 byte te
of
Th m in meout is fixed to 5 sec.
REG17: Terminator Setup 2 Default value
rminator. In case of a 2-byte terminator, set the first byte character
the terminator.
e co mand put ti
: 32H
Set another arbitrary 1 byte terminator. In case of a 2-byte terminator, set the last
of the terminator.
character
REG18: Communication Setting 1 [default value: 8CH]
Bits 7 – 6: Reserved
• The FRH-SD07TU/TB does not use this register. Keep the default value as it is.
Rev. 050415-01.1