User's Manual

Page 63
B 4its – 0: Group Number
Group No. Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 0 0 0 0 0
1 0 0 0 0 1
2 0 0 0 1 0
3 0 0 0 1 1
4 0 0 1 0 0
: : : : : :
: : : : : :
19 1 0 0 1 1
20 1 0 1 0 0
21 1 0 1 0 1
22 1 0 1 1 0
23 1 0 1 1 1
Table 5–3: Frequency Group Settings
ber is set. Valid group numbers fo
[default value: 05H]
• The frequency group num r setting vary
depending on the frequency grouping method.
REG07: RS485 Packet Interval
• In the nsmission m h the RS485 e is set
between re nse and/or h output from the m em to RS485 line.
• Be able to set 0 to 254 ms ms. 255m s not a ed. T default
value is 5
• Set this interval to a large ceiving in rval set by REG14.
• Suitable setting of this inte ata collision possibility of RS485 line.
For details, refer to p.31 C NCE IN RS485 INTERFACE
packet tra ode wit mod used, s the interval
spo received data whic od
at increment of 1 s i llow he
ms.
r value than the re te
rval avoids the d
OLLISION AVOIDA
.
REG08: Reserved [default value: 11H]
• The FRH-SD07TU/TB does not use this register. Keep the default value as it is.
R ult value: 13H] EG09: Reserved [defa
• The FRH-SD07TU/TB does not use this register. Keep the default value as it is.
REG10: Command Header [default value: 40H]
• Sets the character that identifies the start of a command.
• The default is character “@” (40H).
Futaba Corporation Rev. 050415-01.1