User's Manual
Page 78 FRH-SD07TU/TB Manual
REG27: Frequency Band Setting [default value: 01H] s
Bit 7 – 6: reserved
• The FR -S r. Keep the default value as it is.
Bit 5 – 4: Output clock ra
Bit 5 Bit 4 Setting
H D07TU/TB does not use this registe
te of AUX terminal
0 0 No clock output (default value)
0 1 100KHz
1 0 1.14MHz
1 1 8MHz
Table 5–30: Setting of output clock rate of AUX terminal
• Sets the operation clock rate of the output signal of the AUX terminal for the status
ires
hig
clo ption.
• or the function of the AUX terminal, refer to p.151 AUXILIARY INTERFACE
monitor use. Some of the status data contains high speed one-shot signals, which requ
h speed clock to properly catch. Because of higher current consumption when higher
ck rate, this parameter controls the clock rate to decrease current consum
F .
B 3it – 0: Frequency band setting
Bit 3 Bit 2 Bit 1 Bit 0 Setting
0 0 0 0 Invalid (forced to 0001)
0 0 0 1 2433-2479MHz (default value)
0 0 1 0 Do not set (Invalid)
0 0 1 1 01 Band
0 1 0 0 02 Band
0 1 0 1 2420-2466MHz 2MHz Separation
0 1 1 0 2423-2469MHz 2MHz Separation
0 1 1 1 Reserved
1 - - -
Table 5–31: Frequency band setting
• For the frequency band, refer to p.35 FREQUENCY BAND
.
• For the FRH-SD07TB users in France and Spain, frequency usage is restricted to 02
Band because of its country’s regulatory authority. Also please refer p.35 FREQUENCY
BAND for its details.
Rev. 050415-01.1