User's Manual
Page 80 FRH-SD07TU/TB Manual
6.1 Comm and Se t Description
This section provides a description of each command available in the FRH command set.
The table below lists each command and it applicability in each operation mode.
Command Function Command to Mode
Availability
3 4 5 6
1 ARG
Reference All Memory Resisters
2 BCL
Clear Transmit and Receive Buffers
—
—
3 BIV
Reference and Set Beacon Interval
—
—
4 BST
Read Buffer Status
—
—
5 DAS
Reference and Set the Destination Address
——
—
6 DBM
Read Signal Strength
—
—
7 FRQ
Reference and Set Frequency Group
—
8 INI
Initialize All Memory Resisters
9 ODA
Disable Received Data Output
—
—
10 OEN
Enable Received Data Output
—
—
11 PAS
Reference and Set Repeater Address
——
—
12 POF
Transmit Directly to Receiver
——
—
13 PON
Transmit through Repeater
——
—
14 RBC
Clear Receive Buffer
—
—
15 RDA
Disable Wireless Reception
—
—
16 REG
Reference and Set Memory Resisters
17 REN
Enable Wireless Reception
—
—
18 RID
Display Received Serial ID
—
—
19 RLR Release ULTRA Mode Through Repeater
—
—
20 RLU Release ULTRA Mode (Direct)
—
—
21 RNO
Reference and Set Retransmission Count
—
—
22 ROF RF Circuit Block Power Down
23 RON RF Circuit Block Power Up
24 RPT
Retransmit Message
—
—
25 RST
Reset
26 RTY
Retransmit Message Through Repeater
—
— —
27 STS
Read Status
—
—
28 TBC
Clear Transmit Buffer
—
—
29 TBN
Transmit Binary Data
—
— —
30 TBR
Transmit Binary Data Through Repeater
—
— —
31 TID Display Local Station Serial ID
—
32 TXR
Transmit Text Data Through Repeater
—
— —
33 TXT
Transmit Text Data
—
— —
34 VER
Reference Version Information
= available
— = unavailable or invalid
Table 6–1: Command to Mode Availability
Rev. 050415-01.1