FUTK9280 12K Manual

164
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
MOTOR
[Correspondingmodeltype]:Airplane/glider,general
This function lets you set the speed when the
motor of an F5B or other EP glider is started via
a switch. The operation speed can be set for two
ranges, slow speed flight and high speed flight
(Speed1/Speed2). This function can also be
operated as a safety function by programming it to
a switch.
●TheInsideandOutsideoperating speedscan
beadjustedindependentlyin2ranges(Speed1/
Speed2).
●Theboundarybetweenthe2rangescanbeset.
(FromSpeed1toSpeed2)
●Theoperationalspeed canonlybeactivatedat
theinitialoperation.However,operationcanbe
repeatedbysettingtheswitchtoOFFbefore the
operationisnished.Whenyouwanttoreset,one
timeoperation,settheACT/INHitemto[INH]and
thenresetitto[ON].
●ThemotorchanneliscontrolledbySW-G.(Glider:
Initialsetting)Whenchangingtheswitchorstick
whichcontrolsthemotor,rstchangeFunctionof
the Linkage menu.
●IftheModelTypeselectedisAirplane,theMOTOR
functionischangedfromINHtoONanditisnot
assigned to another channel. The changes from
the throttle channel to the motor channel are
enabled.
Note: Initial setting does not assign a motor
channel according to the model type. Prior to
assigning the motor channel, nd an unused
channel. Then, use the Function menu of the
Linkage menu.
Set [Control] to the switch you want to use
and [Trim] to [--].
Note: When using this function, always check
the initial operation with the propeller
removed.
●Select[MOTOR]attheModelmenu
and access the setup screen shown
below by pushing the RTN button.
Setting method
● Activate the function
When using this function, move the cursor to
the[ACT/INH]itemandpushtheRTNbutton
toswitchtothedatainputmode.Selectthe
[ACT]byscrollingthePushdialandpushthe
RTN button.
 WhenselectingtheON/OFFswitch,movethe
cursor to the switch item and push the RTN
buttontoaccesstheselectionscreen.Select
theswitchandsetitsONdirection.(Always
ONat"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
● Motor off position setting
 Movethecursortothe[MOTOROFF]item
and push the RTN button for one second
whenthemotorfunctionswitch(SG,etc.)isin
theMOTOROFFpositionyouwanttoset.The
direction of the motor switch is memorized.
ThescreengraphdisplayOFFdirectionalso
changes.
Note:
● First decide the motor OFF direction, and then
set the speed. When you want to reset the
motor OFF direction, also reset the speed.
● We recommend that Motor OFF be set in
combination with F/S.
● Set the basic operation direction with the
Reverse function to match the ESC used.
● Always set the Motor OFF position.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered