4PM Manual

Alarm time (ALRM)
OFF, 1 ~ 99 m
Initial value: 5 m
Switches
Time start / stop
Status display
RST: Reset state
RDY:
Throttle trigger operation wait
RU: Timer running
STP: Timer stopped
Operation wait
: Press the (JOG) button
TRG: Throttle trigger operation
Status display
RST: Reset state
RDY:
Throttle trigger operation wait
RUN: Timer running
STP: Timer stopped
111
Function
Timer Function "TIMER"
(Preparation)
Select the setting item "TYPE" by moving the (JOG) button up
or down. Press the (+) or (-) button and select "UP".
1
(Alarm time setting)
Select the setting item "ALRM" by moving the
(JOG) button up or down. Set the alarm time
with the (+) or (-) button.
2
(Timer start/stop operation)
Start the timer by pressing the switch ("TIMER")
set by function select switch function. Stop the
timer with the same switch that starts it.
- Linking only start to the throttle trigger
Select the setting item "RST" by moving the
(JOG) button up or down and press the (JOG)
button for approximately 1 second. When the
set beeps and the status display switches from
"RST" to blinking "RDY", the system enters the
trigger operation ready state. When the trigger
is operated at the forward side, the timer starts.
(Status display "RUN")
If the (END) button is pressed while the timer is
operating, the LCD returns to MENU screen.
3
(Timer reset operation)
Select a status display ("RUN" or "STP") by
moving the (JOG) button up or down and press
the (JOG) buttons for approximately 1 second.
A beep is generated and "RST" appears on the
status display and the timer resets.
Using the up timer
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Press the (+) and (-) buttons si-
multaneously (approx. 1 sec) to
return to the HOME screen.