6K Transmitter - Manual

Beforeuse
41
ŵŖœœŔŶť

ŦūŃŰŲŧŨ
7KH56%UHFHLYHULVDYHU\FRPSDFWXQLW,WKDV6%86RXWSXWVDQG6%86RXWSXWV$GGLWLRQDOO\
WKH6%86RXWSXWVFDQEHFKDQJHGIURPFKDQQHOV6%86FKDQQHOWR3:0FKDQQHO
+RZWRFKDQJHWKH56%&KDQQHOPRGH
6%86
⇔
&+
7KH56%LVFDSDEOHRIFKDQJLQJLWVFKDQQHODOORFD-
tions as described in the table below.
1 Turn on the receiver. (At this moment, the
transmitter should be off.) Then, LED blinks
RED in about 3 seconds. Next, wait until it
becomes solid RED.
2 Press and hold the Mode switch more than 5
seconds.
3 Release the button when the LED blinks RED
and GREEN simultaneously.
4 The receiver is now in the "Operation CH Set"
mode. At this moment, the LED indicates
FXUUHQWVHWVWDWXVWKURXJKÁDVKLQJDSDWWHUQ
that corresponds to the CH mode.
ModeA ModeB
3/S.BUS 3CH S.BUS
RedLEDblink 1time 2times
56%&+0RGHWDEOH
Default CH mode
*Cannot exit this CH setting mode before the operation mode is
¿[HG
6HHWKHEHORZWDEOHWKDWVKRZVFRUUHVSRQGHQFHEHWZHHQ&+
PRGHDQGZD\RIÀDVKLQJ/('
'HIDXOW&+PRGHLV0RGH%6%86
5 By pressing the Mode switch, the operation
CH is switched sequentially as " Mode B"
"Mode A" "Mode B"....
6 The operation mode will be set by pressing
the Mode switch more than 2 seconds at the
desired CH mode.
7 Release the button when the LED blinks
RED and GREEN simultaneously. Then, the
RSHUDWLRQ&+LVÀ[HG
8 After confirming the operation CH mode is
changed, turn off and back on the receiver
power.
7KH³2SHUDWLRQ &+ 6HW´PRGH FDQQRW EHFKDQJHG GXULQJ WKH
receiver communicates to the transmitter.
WARNING
6%86FRQQHFWRUV
Don't connect servo for con-
ventional system to S.BUS
port.
'LJLWDOVHUYRIRUFRQYHQWLRQDOV\VWHPĺ
,WGRHVQRWRSHUDWH
$QDORJVHUYRĺ,WPD\FDXVHDEQRUPDO
KHDW¿UHDQGEXUQLQJ
PWM3ch
S.BUS