16IZ Radio System Manual - Full

143
→ GO to TABLE OF CONTENTS
Trim mix 1/2
[Corresponding model type]: Glider, general
These functions call the ailerons, elevators, and
aps (camber aps, brake aps) trim oset rates
preset according to the ight state.
The amount of ailerons, elevator, and flaps
(camber ap, brake ap) trim oset can be set to a
switch.
As an example Trimmix1 can be set up for
launching, with speed aps and ailerons dropped,
and a slight amount of up elevator. Trimmix
2 can be used for high speed flying, with both
ailerons and speed aps reexed slightly, and a bit
of down elevator.
The trim functions can be activated during
ight by setting a switch. To prevent sudden trim
changes when switching ight conditions, a delay
can be set to provide a smooth transition between
the two. Trim mix 2 will have priority over Trim
mix 1.
The o󱐯set rate of ailerons, aps and elevators can be adjusted.
Tap to the corresponding setting item. Adjust the rate.
Example
1. Move to the [INH] item
.
Set the trim mix function to
[ON].
*When separating the settings for each condition, move to
the [Group] item and set it to [Single].
2. Select the ON/OFF switch.
3. Select the [Manual] or [Auto] mode.
In the [Auto] mode, also select an auto SW. This
switch can be linked to a stick, etc.
<Speed>
In: The operation speed at switch ON can be set.
Out: The return speed at switch OFF can be set.
<Fine Tuning>
The offset rate can be varied in the Fine Tuning
numeric range set at screen by VR, etc. selection.
<Condition Delay>
When ight conditions are set, the operation speed
can be set for each condition. Condition delay
operation can be interrupted and each rudder
quickly returned to its original position by selecting a
cut switch.
● Select [Trim mix1 or 2] at the model
menu and call the setup screen
shown below.
When using this
function, Tap [INH].
(ON is displayed.)
The ON/OFF switch of
mixing is chosen.
Manual/Auto mode
selection
Manual: Switches the
function ON/OFF by
switch
Auto: Trim mix function
call can be linked to a
stick, etc. A stick switch,
etc. separate from the
function ON/OFF switch
is set.
Condition delay setting
Condition delay cut
switch
In speed
Out speed
（First）0 ～ 27（Slowly）（First）0 ～ 27（Slowly）
*The display screen is an example. The actual
screen depends on the Model Type.
When a ne tuning VR
is set, the trim rates
of ailerons, aps and
elevators can be adjusted.
To next page
●Return to Model menu
The value inside the
parentheses shows the
current rudder position.