16IZ Radio System Manual - Full

150
→ GO to TABLE OF CONTENTS
Motor
[Corresponding model type]: Airplane/glider, general
This function lets you set the operation speed when
the motor of an F5B or other EP glider is started by
switch. The operation speed can be set in 2 ranges
of slow speed ight and high speed ight (Speed 1/
Speed 2). This function can also be operated as a
safety function by setting 2 switches.
● The in side and out side operating speeds can be
adjusted independently in 2 ranges (Speed 1/
Speed 2).
● The boundary between the 2 ranges can be set.
(From speed 1 to speed 2)
● The set operation speed operation can be
activated at initial operation only. (1 time
operation) However, operation can be repeated
by setting the switch to OFF before operation is
nished. When you want to reset 1 time operation,
set the ACT/INH item to [INH] and then reset it to
[ON].
● The motor (CH3) is controlled by SW-G. (Initial
setting) When changing the switch or stick which
controls the motor, rst change Function of the
Linkage menu.
Note: When using this function, always check initial
operation with the propeller removed.
● When using this function, Tap [INH].
● When you want to set the "One time mode",
tap to the [One time] item and tap the
screen.
● Speed 1 to 2
The speed 1 and speed 2 region boundary
can be changed,
● Operation speed adjustment
The speed when speed 1 and speed 2 are
ON (In) and OFF (Out) can be adjusted.
● When using this function, Tap [INH].
● Group/single mode switching
(For more information, see the description
at the back of this manual.)
● Switch
A switch that turns the function itself
ON/OFF can be selected.
● Motor off position
Tap the motor off button when [SW-G] is in
the motor OFF position you want to set. The
direction of the motor switch is memorized.
The screen graph display OFF direction also
changes.
Notes
● First decide the motor OFF direction, and then
set the speed. When you want to reset the
motor OFF direction, also reset the speed.
● We recommend that motor OFF be set in
combination with F/S.
● Set the basic operation direction with the reverse
function to match the ESC used.
● Always set the motor OFF position.
● Select [Motor] at the model menu and
call the setup screen shown below.
●Return to Model menu