16IZ Radio System Manual - Full

40
→ GO to TABLE OF CONTENTS
Systemmode
• System(FASSTest18CH etc.)
Type is displayed here.
Batteryvoltageforreceivers
• In FASSTest/T-FHSS mode, this
data displayed. RX voltage
and Ext voltage display
Thereceptionofthesignalfromthe
receivertothetransmitterisshown.
• This does not affect ight.
Timer1,Timer2
• Timer is displayed here.
Tap the time button to start/stop the
timer. (When the screen is tapped for
1 second, timer is reset to the initial
value.)
Home Screen
Digitaltrim(T1toT4)
• Trim position is displayed
here.
ModelName
• The model name that
is currently used is
displayed here.
RF Indicator
User'sname
Systemtimer
• This shows the accumulated time
since the latest reset. (Each model /
Total)
(Hour):(Minute):(Second)
This is the Home screen and descriptions of its menus. Use your nger to operate the touch screen.
→ (Menu)
• Model menu
Tap the Icon to call Model
Menu screen.
→ (Menu)
• System
• Linkage
• Model select
Tap the button to call each Menu
screen.
BatteryIndicator
• When battery is low, the alarm
will beep. Land your aircraft
immediately.
Condition name
• The condition name
that is currently used
is displayed here.
WARNING
Be sure to conrm the model name before ying your aircraft.
Check the battery voltage as often as possible and try to charge the battery earlier.
If the battery alarm makes a sound, land your aircraft immediately.
*You can adjust the LCD contrast by the display setting in the system menu.