16IZ Radio System Manual - Full

→ GO to TABLE OF CONTENTS

● Long press the [U.MENU/

MON.] button in the

Home screen to call the

setup screen shown.

＜or＞

Each channel movement can be checked.

Select the [OFF] or pushing the

HOME/EXIT button → Testing is

stopped

[Neutral]: Mode which locks each servo in the

neutral position

[Moving]: Mode which repeats operation of

each servo

Servo monitor

Servo Test & Graph Display / Displays servo positions.

This is used for testing servo movement. “Moving

Test” (repetition mode) and “Neutral Test” (fixed

position mode) are available.

The “Neutral Test” is good for nding the neutral

position of a servo horn.

In order to prevent any potential difficulties,

the servo test function will be inoperable, or

inaccessible, under certain conditions. Specically,

the Servo Test function is not operational if the

Throttle cut is ON in either airplane or helicopter

modes; or if the Throttle hold is ON in helicopter

mode.

● Select [Servo monitor] at the linkage menu and

call the setup screen shown below.

WARNING

Don't set a servo test mode when the

drive motor is connected and the engine

has been started.

■Inadvertent rotation of the motor or acceleration of the engine

is extremely dangerous.

Test mode change :

OFF → Neutral → Moving

●Return to Home or

Linkage menu