User Manual

100
＜ Linkage menu ＞
rpm
A setup of the rpm
on which the alarm
operates.
↑ An upward arrow
will show that an alarm
will sound when the
rpm rises above the set
value.
↓ A downward arrow
will show that an alarm
will sound when the
rpm falls below the set
value.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
The ON/OFF switch
of Speech is chosen.
ŏ Tap the [rpm sensor] button in the Telemetry screen
to call the setup screen shown below.
Max. and min. values
since the power
was turned ON will
display.
,WFDQQRWEHXVHGLQ)$667PRGHDQG6)+66PRGH
2QO\UHFHLYHUYROWDJHDQG(;7YROWDJHFDQEHXVHGLQ
)$667HVW&+PRGH
7KH)$667HVW&+7)+66PRGHFDQXVHDOOWKHWHOHPHWU\
IXQFWLRQV
Type 1
Type 2
Type 3
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
Telemetry : RPM Sensor
Displaying data from the rpm
7KH5306HQVRUVFUHHQLVXVHGWRVHWXSDQ
RSWLRQDOUSPVHQVRUDQGGLVSOD\WKHURWDWLRQ
LQIRUPDWLRQLWWUDQVPLWV
7KHURWDWLRQRIWKHPRGHOHQJLQHPRWRUHWF
ZKLFKLVÀ\LQJFDQEHVKRZQ
,ILWEHFRPHVKLJKHURUORZHUWKDQWKHVHWWLQJDQ
DODUPDQGRUYLEUDWLRQZLOODOHUW\RX
Alarm set : Over
（
Under
）
rotations
1. Tap Alarm and choose from Bu]]er, Voice,
and Inhibit.
2. When not operating vibrator, it is
"
Vibrator" to
Inhibit. Type1-3 will be chosen if it is made to
operate.
3. Tap to the Limit [
xxx
rpm] item .
4. Adjust the rate by "ʈʈ" "ʈ" "ʆ" "ʆʆ" button.
Initial value: Ń 2,000rpm Ņ 0rpm
Adjustment range: 0rpm~150,000rpm
(ŃLimit
≧
ŅLimit)
:KHQWKHVFUHHQLVWDSSHGIRURQHVHFRQGWKHUDWHLVUHVHW
WRWKHLQLWLDOYDOXH
5. To terminate the input and return to the
original state, push the HOME/EXIT button.
*A rpm sensor must be installed in the aircraft.
"Magnet"
"Optics"
"Brushless motor"
SBS-01RM →
SBS-01RO →
SBS-01RB →
Gear ratio
Blade
Pole
1.0099.00
210
230
ŏReturn to
Linkage menu