INSTRUCTION MANUAL F-14 INSTRUCTION MANUAL F-14/F-14 Navy P-CBF14N / P-CBF14NB
INSTRUCTION MANUAL F-14 SAFETY WARNINGS WARNING: SAFETY WARNINGS, PLEASE READ. Before operating your model for the first time, you must read these instructions very carefully, especially the Do not touch the antenna during flight as transmission is reduced significantly. safety warnings. If this is your first time operating a remote controlled car, boat, plane or helicopter we recommended that you seek advice from an experienced pilot.
INSTRUCTION MANUAL F-14 1. FUTABA F-14 RADIO CONTROL SYSTEM 2. THE F-14 TRANSMITTER You are now the owner of a multi-option radio control set with extensive expansion facilities which give you the chance to create a system which meets your personal requirements exactly. The F-14 transmitter features an angled front face and includes five option wells to take your choice of extra modules.
INSTRUCTION MANUAL F-14 3 1 2 1 14 4 13 5 12 6 7 11 5 8 9 1 2 3 4 5 6 7 antenna battery voltage display option field stick func. 3+4 trim func. 3 trim func. 4 option fields slider 8 9 10 11 12 13 14 10 2 option field 3 on/off switch fastener sliders trim func. 1 trim func. 2 stick func. 1+2 option field 1 main pcb 2 charging socket 3 battery box and option field 3 3 4 4 antenna compartment 5 connector for battery Fig. 3 Fig.
INSTRUCTION MANUAL F-14 Changing crystals The notes above regarding the transmitter battery also apply to the receiver pack. Please note that all rechargeable batteries in the RC system should be given a slow charge at the 1/10 rate (standard charge rate, example: 500 mAh battery-charge current 50 mA) for at least 14 hours, regardless of how long you used the system last time. This compensates for the fact that NiMH batteries self-discharge when stored.
INSTRUCTION MANUAL F-14 Specification where you put it instead of returning to centre automatically. This type of function is required, for example, to control the throttle of a glow motor. The set is supplied with a ratchet spring and retaining screw for this purpose. You can place the throttle function on the right or left stick to suit your preference. 1 6 2 3 1 position for ratchet func. 2 2 screw for spring func. 1 3 screw for spring func. 2 4 5 4 screw for spring func.
INSTRUCTION MANUAL F-14 The receiver aerial must be laid out full-length in as straight a line as possible, and kept as far as you can away from electric motors, servos, high-current cables and metal pushrods. In model aircraft it is best to run the aerial out of the fuselage by the shortest route and attach it to the fin under light tension using a small rubber band.
INSTRUCTION MANUAL F-14 Fig. 15 shows a typical suppression arrangement of an electric motor. Always extend the transmitter aerial fully before you start using the system to control a model. When operating your model do not point the transmitter aerial straight at it, as the radiated power of the transmitter aerial is at its lowest in this direction. It is best to stand with the aerial at right-angles to the model.
INSTRUCTION MANUAL F-14 the blind cover from the well by undoing the two screws. The switch can then be fitted in the desired location from the inside, and the retaining nut fitted on the outside. You will need to break out the switch position carefully from the blind cover using a pair of tweezers or pointed-nose pliers before screwing the cover in place again. refer to the operating instructions supplied with the Multi-Prop decoder. 2.
INSTRUCTION MANUAL F-14 To install the Twin Stick unit in the transmitter the back panel must first be removed; this procedure is shown in detail in figure 2. First disconnect the battery cable, then remove the four screws from the front panel which hold the dual-axis stick unit which you wish to replace. The two connecting leads to the main circuit board must then be disconnected. The original stick unit can now be removed from the case and stored in a safe place for possible later use.
INSTRUCTION MANUAL F-14 11
INSTRUCTION MANUAL F-14 DECLARATION OF CONFORMITY Ripmax Ltd. declares that this transmitter conforms to all relevant European directives. The original declaration of conformity can be found under www.ripmax.com. At the item description, there is a link called „declaration of conformity”. PERMISSIONS The Radio Equipment (RED) directive is the new European directive for transmitters and telecommunication devices and their conformity.
