Users Manual Part 3

(HOME screen)
MENU-1
MENU-2
MENU-3
(ADJUSTER screen)
(MENU 4)
Select
" ADJUSTER"
71
Function
fi g-1
fi g-4
fi g-2 fi g-3
Adjuster "ADJUSTER"
(Preparation)
On the ADJUSTER screen, select the setting item "WHEEL"
by moving the (JOG) button up or down, and press the (JOG)
button.
1
(Steering neutral adjustment)
In the neutral setup screen (fi g-1) state, lightly pull the steering
wheel and then press the (JOG) button without touching the
wheel.
2
(Steering throw adjustment)
In the throw setup screen state (fi g-2), lightly turn the wheel
fully to the left or right and when button mark (fig-3) is dis-
played, press the (JOG) button.
Internal check is performed automatically. When each adjust-
ment point is within a fi xed range, correction is performed and
"COMPLETE" (fi g-4) is displayed.
If an adjustment point is not within a fi xed range, correction is
not performed and the correction data is not updated.
When button mark is not displayed even though correction was
performed again, please contact a Futaba Radio Control Cus-
tomer Center.
3
When finished with setting, return to the ADJUSTER screen by
pressing the (END) button.
Steering adjustment
Adjuster "ADJUSTER"
Steering wheel and throttle trigger neutral position and servo operating angle correc-
tion can be applied. This is used when a mechanical offset has occurred for some rea-
son.
*However, when correction is made, the set value of all the setting functions must be
rechecked.
Display the
"
ADJUSTER
"
screen using the following method:.