Users Manual Part 3

80
Reference
When Using Four Dry Batteries
When ribs in the battery case are cut by the following method.
-
Cut out the six ribs inside the battery case referring to the figure.
- Insert the dry battery box 4P-SQ
from the wiring side as shown
above.
Cut rib
Coution
When putting the dry battery box in the transmitter, please put it in the case from the side with wiring. Also,
when removing, please remove from wiring side.
When installing and removing from the side opposite to the instruction, there is a possibility that the wiring is caught in the case and it
is disconnected or short-circuited.
Warning
Be alert when using a cutter knaife or nipper.
Failure to use it or neglect attention may cause injury and is extremely dangerous.
When changing to four the AA size dry batteries, be sure to change the battery type to
"
CSTM
"
and set the low battery alarm voltage to 4.1 V with the BATT setting (see page
41) of the system menu.
Low battery alarm