User Manual

ManualsBrandsFUTEK ManualsSensorsLLB Series

90°

This drawing is submitted solely for the information and

exclusive use of the original addressee. It is not to be divulged

in whole or in part, by any firm or individual without written

permission from FUTEK

Drawing Number: F3131

RECESSED

PLATE

RETAIN WITH

SET SCREW

CAUTIONS

MOUNTING

MAINTAIN CLEAN

SURFACE

SUPPORT ON THE

OUTER RING ONLY.

1) DO NOT PULL ON OR CARRY SENSOR BY CABLE.

2) BE CAREFUL NOT TO APPLY EXCESSIVE FORCE ON

OR MOUNT ANYTHING IN CONTACT OF THE

DIAPHRAGM AREA.

3) ANY TAMPERING OR REMOVAL OF COVER, CABLE

AND/ OR CONNECTOR WILL VOID WARRANTY

4) ALWAYS HAVE SENSOR PLUGGED IN DURING

INSTALLATION TO MONITOR OUTPUT TO AVOID

PERMANENT ZERO SHIFT AND OVERLOAD.

LOAD SHOULD BE

APPLIED IN LINE

LOAD SHOULD BE

APPLIED ON THE

CENTER OF THE

BUTTON

SECURE FROM

OUTER LIP

LOAD BUTTONS ARE USED IN

THE MONITORING OF FORCE

APPLIED IN PRESS TYPE

APPLICATIONS.

FIXTURE MUST NOT

CONTACT DIAPHRAGM

AREA

FIXTURE LOAD SURFACE

MUST BE IN LINE WITH THE

SENSOR

SENSOR CAN NOT BE

USED IN TENSION.

SIDE LOAD MAY DAMAGE

THE SENSOR

THREADED LOAD PROBE TYPESTANDARD

FLAT AND EVEN SURFACE

REQUIRED

1 2

7 8

FURTHER MOUNTING SUGGESTIONS

DIAPHRAGM

MOUNT IN

C'BORE HOLE

MOUNT USING

THREAD HOLES

SENSOR MAY BE

USED TO

MONITOR

FORCES

IN AN ARBOR

PRESS

DIAPHRAGM