Owner manual

This drawing is submitted solely for the information and
exclusive use of the original addressee. It is not to be divulged
in whole or in part, by any firm or individual without written
permission from FUTEK
CAUTIONS
MOUNTING
MAINTAIN CLEAN SURFACE
LOAD FIXURE MUST CONTACT
TOP INNER RING ONLY
SUPPORT FIXTURE MUST
CONTACT LOWER OUTER
RING ONLY
1) DO NOT PULL ON OR CARRY SENSOR BY CABLE.
2) BE CAREFUL NOT TO APPLY EXCESSIVE PRESSURE ON
OR MOUNT ANYTHING IN CONTACT OF THE DIAPHRAGM
AREA.
3) LOAD MUST BE APPLIED UNIFORMLY ON ENTIRE LOADING
SURFACE
4) ANY TAMPERING OR REMOVAL OF COVER, CABLE AND/
OR CONNECTOR WILL VOID WARRANTY
5) ALWAYS HAVE SENSOR PLUGGED IN DURING
INSTALLATION AND HANDLING TO MONITOR OUTPUT
TO AVOID PERMANENT ZERO SHIFT AND OVERLOAD.
SUGGESTED MOUNTING
FORCE WASHER CAN BE
USED TO TELL THE
FORCE BETWEEN TWO
PLATES BOLTED TOGETHER.
SENSORS CAN BE
USED TO MONITOR FORCE
APPLIED IN PRESS
APPLICATIONS.
HARDENED
WASHERS
FORCE WASHER DONUT/ THRU HOLE
L2700 SENSOR TYPE
L2760 SENSOR TYPE
Q07474
FLAT AND EVEN SURFACE
REQUIRED
1 2
3
5
6
4
7
FORCE/ LOAD WASHER
W/ REMOVABLE LOAD
BUTTON
**APPLICABLE TO DONUT/ THRU HOLE ONLY**
THRU HOLE/ DONUT
FORCE WASHER
SENSORS CAN BE
USED TO MONITOR
VOLUME IN HOLDING
TANK APPLICATIONS.
INNER
RING
OUTER
RING
FORCE
WASHER
HARDENED
WASHERS
DIAPHRAGM
AREA