User Manual

Futek Advanced Sensor Technology – Futek VCal™Documentation Rev. 1.8.0 07/26/05

©Futek Advanced Sensor Technology 2005

7. Once the installation is complete you will see the Installation Complete screen, simply click Close here and your VCal™

installation is complete!

Connecting Your VCal™ System

Now that you have successfully installed your Futek VCal™ system, it is time to connect your VCal™. Futek VCal™ is very simple to

connect. For best results we recommend that you connect your VCal™ in the following manner; Please note the General Safety pre-

cautions listed on (page 57) before connecting your VCal™.

1. Plug in the DC Power Supply (included with your VCal™) into the wall outlet and then into your VCal™ unit.

2. Push in the ON/OFF power button, the red power LED should light.

3. Plug the USB cable (included with your VCal™) into the USB outlet on your PC

4. Plug the USB cable into your VCal™ unit, and plug your Temperature Probe into the connector on the

Power Face Plate.

5. Your Futek VCal™ unit is now connected.

6. After connecting your VCal™ you should first see the Found New Hardware Screen...