Owner's manual

2
PRECAUTIONS
Look over the unit to make sure no damage has occurred during shipping. Never apply power to a unit that
appears damaged.
Check that the red voltage indicator on the power switch is set to the proper voltage for your country.
To change the voltage selection, first make sure the power cord has been removed from the unit. Open the
voltage selector/fuse cover (near the mounting screw). Gently pry the red fuse holder out of the enclosure,
rotate it 180 degrees and reinsert the fuse holder. Close the fuse cover and verify that the correct voltage for
your country is displayed in the window.
Use the proper pin-style IEC power cord for use in your country.
Replace the fuses only with 250V 1Amp fast-blow type.
Do not open the unit, since there are no user-serviceable parts inside. Dangerous high voltages exist within the
unit even when the unit is unplugged or turned off. Refer all servicing to qualified personnel.
Never expose the db to rain or moisture. If liquids are spilled into the unit, unplug from the power mains
immediately, and let the unit sit in a dry warm environment until all moisture has evaporated.
Avoid exposing the unit to smoke, or to dusty, or extreme hot and cold environments, as these things may
cause premature component failure.
Clean the exterior of the db with a soft dry cloth. Never use abrasive cleaners that may harm the surface and
finish of the unit.
Do not block ventilation holes in the chassis. When rackmounting the db, leave space above and below the
unit for proper ventilation.
Disclaimer
All information represented in this manual is believed to be accurate at the time of publication. Any
addendums to the manual and further product support may be found on the Support page of our Web site:
www.future-retro.com/support.html
Product specifications may be subject to change.
Future Retro assumes no responsibility for inaccuracies, errors, omissions, nor liability for any loss or damage
resulting directly or indirectly from the use, misuse, or abuse of this product.
Information in this manual may not be copied, reproduced, or distributed in any form without permission from
Future Retro.
Warranty
The db comes with a 1-year warranty covering all parts and labor.
Please register your product at: www.future-retro.com