User's Manual
Table Of Contents
- About this document
- Safety Information
- General Radio Operating Procedures
- CMD Technical Description
- CMD Installation (19” rack mount only)
- CMD Programming
- CMD Front Panel Indicators
- CMD Specifications
Important:
amming (or editing the personality of) the currently connected
rogramming the CMD Channel Spacing
rs, the global channel spacing needs to be
When progr
CMD, the user will be asked “Would you like to update the EEPROM” every
time he / she tries to close the currently open programming screen. Select
“Yes” if the changes need to be kept after the CMD is reset. For some of the
changes to take effect the CMD must be reset.
P
Prior to setting up the rest of the CMD paramete
selected. This is done from the Frequency Band Setup in the CMD Setup pull down menu.
Adjust the Adj. Ch. Offset / FM Dev field to the correct channel spacing i.e. 25kHz
(NBPF)/3kHz or 12.5kHz / 1.5kHz. All other fields must not be changed by the user.
8A074X06 Rev. Preliminary Page 12 of 15
21/08/2003