User's Manual
Table Of Contents
- About this document
- Safety Information
- General Radio Operating Procedures
- CMD Technical Description
- CMD Installation (19” rack mount only)
- CMD Programming
- CMD Front Panel Indicators
- CMD Specifications
CMD Front Panel Indicators
The CMD front panel has several LEDs which provide the following indications:
LED
Label
LED
Color
DESCRIPTION
TX DIS RED The TX DIS LED is steady on when
transmit is disabled either by:
Triggering the TX DIS switch which
is located above the LED (accessible
with a round tool 2.5mm in diameter)
Setting the Operating Mode field to
Tx-Disable
The TX LED indicator is flashing when one
of the synthesizers is being out of lock.
DC ON GREEN When on it indicates that the CMD is
powered up.
TX ON GREEN When on it indicates that the CMD is
transmitting.
RX ON GREEN When on it indicates that the CMD input
signal is above the programmed level
PWR RED The PWR LED is steadily on when
the output RF power is outside of the
programmed tolerance.
VSWR RED The VSWR LED is on when an excessive
reflected power is detected on the Tx port
8A074X06 Rev. Preliminary Page 14 of 15
21/08/2003