User's Manual
Table Of Contents
- About this document
- Safety Information
- General Radio Operating Procedures
- CMD Technical Description
- CMD Installation (19” rack mount only)
- CMD Programming
- CMD Front Panel Indicators
- CMD Specifications
Safety Information
FCC Class A Digital Device or Peripheral User Information
NOTE:
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, can cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
WARNING
Changes or Modifications not expressly approved by Futurecom Systems
Group Inc. could void the user’s authority to operate the equipment.
USA Users:
Do not use the Digital Channel Module in the frequency band 406.0 -
406.1MHz. This frequency band is reserved for use by distress beacons.
General Safety Information
The following information may or may not be applicable to your product.
In any case, precautions should always be taken when handling any electrical product.
IMPORTANT
This manual contains important safety and operating instructions, therefore keep
this manual always on hand!
Prior to using any product, follow all warning, safety and operating instructions
written on the product and in the user’s manual. All instructions should be
saved for reference in the future!
WARNING
Always keep product dry, never expose to any kind of moisture.
Do Not expose product to extreme temperatures- as found near a hot radiator or
stove.
Do Not expose product to open flames, cigarettes, etc.
Precautions should be taken to avoid objects falling or liquids spilling onto product.
Do Not incorporate the use of other equipment that is not recommended or sold by the
manufacturer. The result may be the risk of fire or electric shock injury.
Connect DC power cord to DC power source as marked on the product.
8A074X06 Rev. Preliminary Page 5 of 15
21/08/2003