User's Manual

DVE
Futurecom Systems Group Inc. DVE Users Manual 8A084X03_Rev1_3.DOC Rev. Preliminary Page 4
NOTE
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
ATTENTION!
Changes or modifications not expressly approved by Futurecom Systems Group Inc. could void the
user’s authority to operate the equipment.
IMPORTANT
This manual contains important safety and operating instructions, therefore keep this manual
always on hand!
Prior to using any product, follow all warning, safety and operating instructions written on the product and in
the Users Manual. All instructions should be saved for reference in the future!
RF EXPOSURE
Model Minimum Separation Distance
From 0dBd Omni Directional
Antenna
DVE VHF
66cm (26.0”)
DVE
UHF
40cm (15.75”)
DVE 700
28cm (11.02”)
DVE 800
28cm (10.63”)
Table 1 DVE Minimum Separation Distance for Different Frequency Bands
ATTENTION!
To satisfy FCC/IC RF exposure requirements, a separation distance as per Table 1 or more should be
maintained between 0dBd (2.15dBi) onmi directional antenna of this device and persons. To ensure
compliance, operation at closer than this distance is not allowed.