Manualshelf

User's Manual

ManualsBrandsFuturecom Systems Group ULC ManualsElectronicsOn-Channel Repeater
12345678910
8A535X01 Rev. Preliminary-02 Page 5 of 19
SAFETY INFORMATION
NOTE
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, can cause
harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
ATTENTION!
Changes or Modifications not expressly approved by Futurecom Systems Group Inc.
could void the user’s authority to operate the equipment.
USA Users:
Do not use the On-Channel Repeater in the frequency band 406.0 - 406.125MHz.
This frequency band is reserved for use by distress beacons.
GENERAL SAFETY INFORMATION
The following information may or may not be applicable to your product.
In any case, precautions should always be taken when handling any electrical product.
IMPORTANT
This manual contains important safety and operating instructions, therefore keep this
manual always on hand!
Prior to using any product, follow all warning, safety and operating instructions written
on the product and in the Users Manual. All instructions should be saved for
reference in the future!
ATTENTION!
Always keep product dry, never expose to any kind of moisture.
Do Not expose product to extreme temperatures - as found near a hot radiator or
stove.
Do Not expose product to open flames, cigarettes, etc.
Precautions should be taken to avoid objects falling or liquids spilling onto product.
Do Not incorporate the use of other equipment that is not recommended or sold by the
manufacturer. The result may be the risk of fire or electric shock injury.
Connect DC power cord to DC power source as marked on the product.