Installation Instructions

8F083X03 Rev 16.2
DVRS-Product Safety and RF Exposure Booklet 6
Installation Requirements for Compliance with Radio
Frequency (RF) Energy Exposure Safety Standards
ATTENTION!
To ensure compliance with RF Energy Safety Standards:
 Install only Futurecom / Motorola approved antennas and accessories and set conducted
power into the DVR and Mobile antennas equal to or lower then the approved power levels –
refer to Table 3 (Stand Alone DVR) or Table 4 (DVR interfaced to XTL Mobile Radio) or Table
5 (DVR interfaced to APX Mobile Radio).
 Ensure the antenna installation is consistent with the DVR Antenna Installation instructions
described in this document as well as with the Mobile Radio Antenna Installation Instructions
published in the applicable Motorola Installation Manual.
 Ensure the Product & RF Safety Booklets 8F083X03(FCC) or 8F083X05(ISED) enclosed
with the Mobile Radio and the DVR are available to the end user upon completion of the
installation.
ANTENNA STAND ALONE DVR MODEL
# Kit #
Freq.
Range
[MHz]
Type
700 MHz
(20W)
(up to 50%
Tx duty
cycle)
800 MHz
(20W)
(up to 50%
Tx duty
cycle)
403-430
(20W)
(up to 50%
Tx duty
cycle)
450-470
(20W)
(up to 50%
Tx duty
cycle)
470-512
(20W)
(up to 50%
Tx duty
cycle)
VHF (20W)
(up to 50%
Tx duty
cycle)
1 HAF4016 764-870 ¼ wave
20W 20W
2 HAE6012A 380-433 ¼ wave
20W
3 HAE4003A 450-470 ¼ wave
20W
4 HAE4004 470-512 ¼ wave
20W
5 HAD4006 136-144 ¼ wave
20W
6 HAD4007 144-150.8 ¼ wave
20W
7 HAD4008 150.8-162 ¼ wave
20W
8 HAD4009 162-174 ¼ wave
20W
Table 3 Approved Stand-Alone DVR Combinations
NOTE:
Mobile RF conducted antenna power in the tables below denotes up to 50% Tx duty cycle.
DVR RF conducted antenna power in the tables below denotes up to 50% Tx duty cycle.