MOBEXCOM DVRS Vehicular Repeater Users Manual 8A083X22 Rev. 4.
Vehicular Repeater System 1. TABLE OF CONTENTS Section 1. Page TABLE OF CONTENTS..................................................................................................... 2 Notes, Attentions, Important ................................................................................................... 3 REPEATER MODES ................................................................................................................................... 7 CONTROL HEAD ............................
Vehicular Repeater System Notes, Attentions, Important Throughout this manual, you will see Notes, and Attentions, Important Their meaning is as follows: NOTE A clarifying statement that expands on the text that follows. IMPORTANT An important statement that should be considered and / or implemented in order to achieve adequate equipment operation. ATTENTION! An instruction that must be followed in insure compliance with the appropriate standards or proper equipment operations.
Vehicular Repeater System NOTE This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Vehicular Repeater System ANTENNA INSTALLATION ATTENTION! To satisfy FCC/ISED RF exposure requirements for mobile transmitting devices, refer to Futurecom 8F083X03 (FCC) or 8F083X05 (ISED) RF Safety Booklet for the approved frequency bands, antenna types and antenna installation restrictions and requirements. IMPORTANT Refer to Futurecom 8F083X03 or 8F083X05 RF Safety Booklet for antenna installation instructions and proper installation locations diagram.
Vehicular Repeater System ATTENTION! Do not use the DVRS in the frequency band 406.0MHz – 406.1MHz. This frequency band is reserved for distress beacons. Futurecom Systems Group ULC. 8A083X22 Rev 4_2E.docxDOC Rev.
Vehicular Repeater System 2. INTRODUCTION The Futurecom MOBEXCOM DVRS® Vehicular Repeater is designed to interface to a range of mobile radios and control heads. It permits expanded operation of portable radios. The Vehicular Repeater system consists of. a mobile radio, MOBEXCOM DVRS® Vehicular Repeater unit, a mobile radio Control Head and a RF multiplexer. The Control Head communicates with the Vehicular Repeater and the mobile using a serial data protocol.
Vehicular Repeater System System Repeat Mode In the SYSTEM repeat mode, both the Mobile Radio and the Vehicular Repeater are enabled at the same time to permit the full exchange of communications among nearby portable radio users, the mobile radio user and the dispatcher and other users on the Mobile Radio channel. Signals received by the Vehicular Repeater receiver are heard in the mobile speaker and may also be retransmitted by both the Vehicular Repeater and Mobile transmitters at the same time.
Vehicular Repeater System ‘Opt’ ‘Home Menu’ ‘Sel’ LED Indicators for: ‘Mobile Transmit’ (Red LED) ‘Mobile Receiver Busy’ (Orange LED) Display: Alphanumeric LCD (with backlighting) Indicators are provided to display the receiver and transmitter status of the mobile. The ‘Mobile Transmit’ red indicator lights whenever the mobile transmitter is keyed. The ‘Mobile Receiver Busy’ orange indicator lights whenever the receiver is busy, regardless of presence or absence of any CTCSS (Channel-Guard) tone coding.
Vehicular Repeater System 3. OPERATION CONTROL HEAD The Repeater Control Head selects mode of operation for both the Repeater and the Mobile Radio. To Turn the Repeater ON or OFF Press the button in the Volume knob located on the left side of the control unit. The display should become active when the system turns ON. A test message appears briefly on the display.
Vehicular Repeater System CONTROL HEAD INDICATORS AND ALPHANUMERIC DISPLAY – MOBILE MODE REPEATER STATE ‘MOBILE BUSY’ ‘MOBILE XMIT’ MOBILE RECEIVE WITH CTCSS MOBILE RECEIVE WITHOUT CTCSS MICROPHONE PTT ON ‘ZONE CHANNEL’ ON ‘ZONE CHANNEL’ ON DISPLAY ‘ZONE CHANNEL’ ‘ZONE CHANNEL’ REPEATER RECEIVE WITH CTCSS REPEATER RECEIVE WITHOUT CTCSS ‘ZONE CHANNEL’ CONTROL HEAD INDICATORS AND ALPHANUMERIC DISPLAY – LOCAL MODE REPEATER STATE ‘MOBILE BUSY’ ‘MOBILE XMIT’ MOBILE RECEIVE WITH CTCSS MOBILE REC
Vehicular Repeater System CONTROL HEAD INDICATORS AND ALPHANUMERIC DISPLAY – SYSTEM MODE REPEATER STATE ‘MOBILE BUSY’ MOBILE RECEIVE WITH CTCSS MOBILE RECEIVE WITHOUT CTCSS MICROPHONE PTT ON ‘RS TX CHANNEL’ ON ‘RSYS CHANNEL’ REPEATER RECEIVE WITH CTCSS REPEATER RECEIVE WITHOUT CTCSS ‘MOBILE XMIT’ DISPLAY ON ‘RS TX CHANNEL’ ON ‘RS RT CHANNEL’ ‘RS RX CHANNEL’ Note that ‘ZONE’ and ‘CHANNEL’ are the selected Mobile zone and channel names, respectively.
Vehicular Repeater System APPENDIX 1 General Specifications Dimensions Height / Width / Depth Weight Channel Spacing 92mm (3.63”) / 186mm (7.32”) / 315mm ( 12.41”) 5.2 kg (11.5 lbs) approx. 12.5 kHz or 25 kHz Analog Voice or P25 Modulation DC Current Drain Power Supply 13.8 VDC 20%, negative ground only Repeater OFF Max. 0.01 A RPTR Standby Max. 0.8 A Receive Max 1.7 A @ 7.5 W Audio @ 13.8 VDC Transmit Max. 6.
Vehicular Repeater System Maximum DVRS power output is programmed by authorized service personnel at time of DVRS installation in accordance with approved DVRS, Mobile Radio and antenna combinations. Power output cannot be changed by the operator CCT Option Carrier Frequency Stability Audio Distortion 15 sec to 15 min. or disabled 1.5 ppm, from –30° to +60°C, ambient +25°C reference <2% Frequency Band (RX and TX) VHF FCC 136 – 174 MHz VHF IC 138 – 174 MHz UHF FCC 380 – 406 MHz, 406.
Vehicular Repeater System Futurecom Systems Group ULC. 8A083X22 Rev 4_2E.docxDOC Rev.
