Installation Manual
Table Of Contents
- Foreword
- Product Safety and RF Exposure Compliance
- Before using this product, read the operating instructions for safe usage contained in the Product Safety and RF Exposure booklet enclosed with your radio.
- ATTENTION!
- This radio is restricted to occupational use only to satisfy FCC RF energy exposure requirements. Before using this product, read the RF energy awareness information and operating instructions in the Product Safety and RF Exposure booklet enclosed wi...
- For a list of Motorola-approved antennas, batteries, and other accessories, visit the following website: http://www.motorola.com/governmentandenterprise
- Document Copyrights
- Disclaimer
- Trademarks
- Spectrum Series™ Base Loaded Mobile Antennas Installation Manual
- Spectrum™ Series Base Loaded Mobile Antennas
- Introduction
- Mobile Antenna Installation
- Spectrum™ by Motorola
- Spectrum™ by Motorola
- Product Safety and RF Exposure Compliance
8 Mobile Antenna Installation
6. Screw adaptor to the body of plug assembly. Solder braid to body of plus assembly through
holes. Solder center conductor of cable to plug contact of plug assembly. Refer to Figure 7F.
7. For final assembly, screw coupling on plug assembly.
8. Connect cable to antenna connector on radio set. Tighten coupling ring cross section of final
assembly as shown in Figure 7G.
NOTE: Coupling ring and plug sub assembly comprise of Motorola part number: 28-82021G01.
Figure 7.
A
B
C
D
E
F
G
Coupling
Ring
Adapter
58-854020
Plug
Sub-Assembbly
TEFLON Washer
(470MHZ and higher)
04-84506K01
3”
4
Adapter
3”
4
TEFLON Washer
(470MHZ and higher)
1/8” of Exposed Insulation
for Lower Frequencies
3”
8
5”
8