Installation Manual
Table Of Contents
- Foreword
- Product Safety and RF Exposure Compliance
- Before using this product, read the operating instructions for safe usage contained in the Product Safety and RF Exposure booklet enclosed with your radio.
- ATTENTION!
- This radio is restricted to occupational use only to satisfy FCC RF energy exposure requirements. Before using this product, read the RF energy awareness information and operating instructions in the Product Safety and RF Exposure booklet enclosed wi...
- For a list of Motorola-approved antennas, batteries, and other accessories, visit the following website: http://www.motorola.com/governmentandenterprise
- Document Copyrights
- Disclaimer
- Trademarks
- Spectrum Series™ Base Loaded Mobile Antennas Installation Manual
- Spectrum™ Series Base Loaded Mobile Antennas
- Introduction
- Mobile Antenna Installation
- Spectrum™ by Motorola
- Spectrum™ by Motorola
- Product Safety and RF Exposure Compliance
Mobile Antenna Installation 7
3. Route coaxial cable from the trunk lid to the radio.
Magnet Mount Installation
1. Remove all dirt and grime that will prevent magnet mount from seating securely.
2. Place magnet mount in final position. Sliding the mount may scratch paint surface.
3. Route coaxial cable to the radio,. Refer to Figure 6.
Figure 6. Magnetic Mounted Base
Connector Installation
Before installing the connector, cut off any excess length of cable (at the radio end) to avoid
unnecessary signal loss. When the necessary preparations have been made, install the connector
using the following steps:
UHF Connector (Motorola part # 28-82021G01)
1. Disassemble the connector as shown in Figure 7A.
2. Cut off end of cable squarely and remove 3/4” of vinyl jacket. Refer to Figure 7B.
3. Slide coupling ring and adaptor on cable as in Figure 7C.
4. Fan braid slightly and fold back as shown in Figure 7D.
5. Position adaptor to dimension as shown in Figure 7E. Press braid back over body of adaptor
and trim to 3/8”. Base 5/8” of conductor. Tin exposed center conductor. Add teflon washer for
470 MHz and higher.
Do not use magnet mount on vinyl roofs, magnet mount will not
properly hold the antenna on vehicle because holding power is
reduced. Magnet mount will not “hold on” to aluminum and non-
metallic surfaces.
Use a hot soldering iron. DO NOT USE EXCESSIVE HEAT
OR SOLDER. Solder quickly to avoid melting surrounding
insulation.
W A R N I N G
C a u t i o n