General Instruction Book

ManualsBrandsFuturo Futuro ManualsCooking Appliances24 Inch Wall Mount Chimney Range Hood with 940 CFM Internal Blower, 4 Speed Electronic Controls, 2 Halogen Lights, Perimeter Suction Filter System and Convertible to Recirculation

INSTRUCTIONS BOOKLET

WARNINGS

This instruction booklet must be kept together with the appliance for future

reference. If the appliance is sold or consigned to other parties, check that

the booklet is supplied with it, to ensure that the new user has the correct

information on the operation of the range hood and is aware of the warnings.

These warnings have been provided for the your safety and the safety of oth-

ers. As a result, please read them carefully before installing and operating the

appliance.

This appliance is not intended for use by young children or infirm persons un-

less they have been adequately supervised by a responsible person to ensure

that they can use the appliance safely. Young children should be supervised

to ensure they do not play with the appliance.

The appliance must be installed by qualified personnel, in accordance with

the standards in force. If the supply cord is damaged, it must be re-placed

by the manufacturer, its service agent or similarly qualified persons in order

to avoid a hazard. Any modifications that may be required to the electrical

system for the installation of the range hood must only be made by qualified

electricians.

It is dangerous to modify or attempt to modify the characteristics of this sys-

tem. In the event of malfunctions or if repairs are required to the appliance,

do not attempt to solve the problems directly.

Repairs performed by unqualified persons may cause damage. For all repair

and other work on the appliance, contact an authorised service/spare parts

centre.

Always check that all the electrical parts (lights, exhaust device), are off when

the appliance is not being used. Read the entire instruction booklet before

performing any operations on the range hood.

The range hood must only be used for the exhaust of cooking fumes in home

kitchens. The manufacturer disclaims all liability for any other use of the ap-

pliance.

The maximum weight of any object placed above the hood, or hung to it (if

possible) must not exceed 1,5 kilos. After installing the stainless steel hood,

clean it in order to remove any residue of the protective glue, and stains of

grease or oil. The manufacturer recommends its cleaning cloth available for

purchase. The manufacturer accepts no liability in case of damage caused by

the use of different detergent types.

TECHNICAL SPECIFICATIONS

The technical data pertaining to the electric appliance The technical specifica-

tions of the appliance are shown on the rating plates located inside the range

hood.

Summary of content (10 pages)

PAGE 1
GB A INSTRUCTIONS BOOKLET WARNINGS This instruction booklet must be kept together with the appliance for future reference. If the appliance is sold or consigned to other parties, check that the booklet is supplied with it, to ensure that the new user has the correct information on the operation of the range hood and is aware of the warnings. These warnings have been provided for the your safety and the safety of others. As a result, please read them carefully before installing and operating the appliance.
PAGE 2
C INSTALLATION (Section reserved for qualified installers of the range hood) Minimum distance: distance between the pan supports of the cooker and the bottom-most section of the hood. When the hood is positioned above a gas equipment this minimum distance must be at least 65 cm (see pictures) or even more, if this is specified in the instructions for use of the gas cooker. In the outside exhaust version, the diameter of the fume discharge duct must be no smaller than the range hood connection.
PAGE 3
the mains power supply. Check that the wires inside the range hood are not disconnected or cut; if this is the case, contact your nearest service centre. The electrical connections must be performed by qualified personnel. The connections must be performed in compliance with the legal standards in force. Check that the relief valve and the electrical system are able to support the load of the appliance (see the technical specifications in point B).
PAGE 4
For maximum efficiency, the third speed should be used when there are strong odours or a lot of steam, the second speed in normal conditions, and the first speed for keeping the air clean with minimum energy consumption. The range hood should be switched on when starting to cook, and left on until the odours disappear. G OPERATION 1. TWO BUTTON CONTROL PANEL LIGHT - Switch A Position 0: the light is off. Position 1: the light is on.
PAGE 5
Pushbutton + Press to increase motor speed Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and the timer LEDs). (In the 4-speed version the pushbutton + blinks. The fourth speed remains on for a set duration of time. After 15 minutes the motor returns to the third speed). Mode pushbutton Function: it turns hood motor on and off. The function “desired speed” enables to start the motor at the speed that was selected before the hood was last turned off.
PAGE 6
H FILTERS REMOVING AND REPLACING’S INSTRUCTIONS 1. METAL FILTERS To remove the metal grease-trapping filter, simply pull the handle A until releasing it from the front guide; then tilt it slightly downwards, and slide it out of the rear guide. To reposition the filter, repeat the operation in the reverse order. A 2. CHARCOAL FILTERS To replace the charcoal filters, proceed as follows: remove the metal filters as described above.
PAGE 7
A WARNING! Light bulbs with different shapes and power ratings from the original may seriously damage the light compartment. 2. SPOTLIGHT To replace the lamp: a) Make sure the appliance is disconnected from the mains power supply. b) Remove, by levering with a screwdriver, the support ring A for the cover glass. c) Remove the cover glass B to access the light compartment. d) Replace the lamp with the same type (halogen, max 20 W, 12 Volt, G4 fitting).
PAGE 8
To remove and replace these filters, see the instructions in point H1. This operation should be performed at regular intervals. The metal filters could be cleaned in a dishwasher. 2. CHARCOAL FILTERS These trap the odours present in the stream of air that passes through them. The air is purified by passing a number of times through the filters and being recirculated into the kitchen. The charcoal filters cannot be cleaned, and should be replaced on average every 3-4 months (according to use).
PAGE 9
- Ensure that all regulations concerning the discharge of exhaust air have been fulfilled before you use the appliance. Before performing any cleaning or maintenance operations, disconnect the appliance by unplugging it or using the main switch.
PAGE 10
Step 2 - Hook the range hood to the support bar (Fig. 2). - Adjust the alignment of the range hood using the screws on the brack-ets (Fig. 2). The top screw (B) adjust the distance from the wall, the bottom screw (C) adjust the height. Step 3 - To prevent the range hood from detaching due to pressure from be-low, fasten it to the wall using a screw anchor and screw, through the corresponding hole (Fig. 3) on the rotor box or inside the mood. - Insert the duct (E) on the ducting connection (D).