Installation Manual

Table Of Contents

[Q]

MOUNTING

INSTRUCTIONS,

RANGE

HOODS

WITH

BOX

Step

- Rest the support

r against the

ll (A-Fig. 1) at a height

from

the cooktop

determined by the

sum

the distance X+Y+31

0mm

- Check

the

horizontal ali

gnment

with

spirit

level and mark the 2 holes

drilled

the ends

the

bar.

• Drill the holes, insert 2 x

8mm

dia. scr

anchors, and fasten the bar using

the corresponding screws.

• •

·····-

-··

•

·1:t

•

Fig. 2

PAGE 1
[Q] MOUNTING INSTRUCTIONS, RANGE HOODS WITH BOX Step 1 - Rest the support ba r against the wall (A-Fig. 1) at a height from the cooktop determined by the sum of the distance X+Y+310mm. - Check the horizontal alignment with a spirit level and mark the 2 holes to be drilled at the ends of the bar. • Drill the holes, insert 2 x 8mm dia. screw anchors, and fasten the bar using the corresponding screws. • • • ·····--··;:· •·1:t Fig. 1 Fig.
PAGE 2
Step 2 • Hook the range hood to the support bar (Fig. 2). • Adjust the alignment of the range hood using the screws on the brack-ets (Fig. 2). The top screw (B) adjust the distance from the wall, the bottom screw {CJ adjust the height. Step 3 • To prevent the range hood from detaching due to pressure from be-low, fasten it to the wall using a screw anchor and screw, through the correspon ding hole (Fig. 3) on the rotor box or inside the mood. • Insert the duct {E) on the ducting connection (D).