Control Panel Functions

EN - 8
REMOTE CONTROL:
1 (top) - LIGHTS ON/OFF - turns the lights on and o.
2 (le) - SPEED DECREASE - lowers the blower speed.
3 (center) - BLOWER ON/OFF - turns on the blower at
2nd speed / turns o the blower.
4 (right) - SPEED INCREASE - increases the blower
speed. At 4th speed (maximum), the LED will ash,
and aer 5 minutes, the hood will automacally de-
crease to 2nd speed.
5 (boom) - TIMER - Delayed Shut-O Funcon: pres-
sing this buon will acvate a 10-minute mer, aer
which the hood will automacally shut o.
REMOTE CONTROL LEARNING MODE (”PAIRING”):
Range hood models equipped with a remote control are already congured.
Models for which an oponal remote control was purchased, need to have the
remote set up at the 1st use.
To set up the remote:
1. DIGITAL / TOUCH / SOFT TOUCH CONTROLS: With the range hood turned
OFF, press and HOLD the “+” buon for 5 seconds.
SOFT TOUCH CONTROLS WITH BACKLIGHT: With the range hood turned OFF,
press and HOLD the “4” buon for 5 seconds.
2. The LED or backlight (depending on model) will start ashing. This indicates
that the hood is in “Remote Learning Mode”.
3. Press any buon on the remote control.
4. LED or backlight will change from ashing to connuously lit for 3 seconds,
then turn o.
5. Conrm that the remote has been “paired” with the range hood by using its
controls. If the range hood does not respond, turn it o and repeat the lear-
ning procedure. If the procedure fails, replace the baery/baeries in the
remote control with fresh ones, and try it again.