User's Manual

TX07 Manual
Initial operation:
` Open the battery compartment on the back of the wireless transmitter by sliding the battery cover in the
direction of the arrow.
` Insert the new batteries, type LR06, in the battery compartment. Check the polarity of the battery during
insertion. This is indicated in the battery compartment.
` Close the battery cover.
` The signal LED at the front of the outdoor sensor will briefly light up. The signal LED will then flash about
twice a minute, indicating wireless transmission.
Set the transmission channel:
` Sliding the CH switch inside the remote’s battery compartment to select Channel 1 or Channel 2 or Channel
3. The Channel number assigned will appear on the remote’s LCD screen.
°C/°F temperature display:
` The temperature is displayed either in °C or °F. Briefly pressing the “°C/°F” button inside the remote’s
battery compartment allows you to switch between the individual models.
Manual transmit signal
` Pressing the “TX” button inside the remote’s battery compartment 1 times, the wireless transmitter will
immediately transmit the 1 wireless data,
The Signal LED and an RF icon on the remote will flash when a
signal is sent.