Instruction Manual

2) Button introduction
Other introductions:
1. Display mode:
There are two display modes, press the button “SET”, you could change the mode of display;
Dp-1: time, temperature and year, month and day display would change orderly (Carousel mode)
Dp-2: only time, temperature display (Fixed mode)
2. Voice Mode (power-saving mode):
Press the button “DOWN”, on: Sd”←→”--:Sd”;
“on: Sd” means sound control in on;
“--: SD” means sound control is off.
It will automatically close the voice mode in seconds; Display will be woke up when the sound is louder than
60 decibels or flapping the clock. If close the voice control mode, constant light function will be opened.
3. Temperature Mode Setting:
Press the button of “UP”, you could change the Temperature Mode between °C and °F
4. Brightness Setting:
Press the button of “UP” for 3 seconds, you could enter into the mode of brightness, then you could change the
brightness through pressing the button of “UP” (more bright) and pressing the button of “DOWN”(less bright).
L1: Bright
L2: Less Bright
L3: Weakest brightness
5. Power supply:
It must use plugged-in power supply when charging the phone.
(The clock with built-in cell battery, it will automatically remember the time when the power is off, we don’t
need to reset the time);
6. Alarm Setting:
User can set 3 alarm times every day, alarm lasting 1 minute, the sound is: beep beep beep, can press any key
on the back of clock to stop the alarm;