Instruction Manual

SETTING INSTRUCTION
Press the button “SET” (While the numbers flashing), you would enter into the setting mode. And the setting
order are as follows:
1. Setting of Date
When entering the set mode, the letter flashing setting order “Year” “Month” “Day”, press button “UP” or
“DOWN” to change the number.
2. 12H/24H Setting
After finishing the setting of date, you would enter into the12H/24H Setting mode while you press “SET”, and
also you could change the 12H/24H through pressing the “UP” and “DOWN”. At the 12H Setting mode, PM
lights on.
3. Time Setting
After finishing the date setting mode, you could enter into the time mode setting while you need to press
“SET” and then you could adjust the time through pressing “UP” and “DOWN”.
4. Alarm Setting
After finishing the time mode setting, you could enter into the alarm setting while you need to continue press
“SET”, and then you could adjust the time through pressing “UP” and “DOWN”.
Press “UP” and “DOWN” can adjust upward or downward too pen on A1/Close -: A1.When the letter “on :
A1” appears ,you could press “SET” and enter into A1 Alarm clock Setting (you could set 3 Alarm clock
A1/A2/A3 ).Then the letter of time “--”flashing, you continue to press “UP” and “DOWN” to set alarm .
You could continue set the Alarm clock A2/A3 follow the step1 and step 2.
5.Alarm Setting For Work Day
After finishing the alarm setting, Press the key “SET”. Then you could press “UP” and “DOWN” to change the
status of on/off workday alarm.(on: E means on; --:E means off.)
◆ ON/OFF button: Press and hold the ON/OFF switch Bluetooth in any mode to search for WOODSHOW
SPEAKER connection. In Bluetooth mode, press this button to answer the call and pause playback.
Wireless charging method: top wireless charging, mobile phone with wireless charging function, or mobile
phone without this function plug in the receiving piece, the receiving part is placed in the middle of the product
to be charged, whether the charging is successful to see the mobile phone prompt. Automatically disconnects
the charge when fully charged.
FCC COMPLIANCE STATEMENTS
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause undesired
operation.
Caution: changes or modifications not expressly approved by the party responsible for compliance could void
your authority to operate the equipment.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
This device must not be co-located for operating in conjunction with any other antenna or transmitter.
The distance between user and products should be no less than 20cm.