Installation Instructions

Warranty Information
For complete warranty details
and exclusions, visit the Product
Support section at www.fypon.com.
QuickRail Plus
Accessories
Bracket Kits
Straight Rail Bracket Kit
Stair Rail Bracket Kit
Multi-Angle Bracket Kit
Posts
Colonial Porch Posts
Column Wraps
Complete Post Kits
Post Sleeves
UltraPost Kits
Post Accessories
Ball Post Top
New England Post Top
New England Post Base
Gothic Post Top
Rail Kits
Straight Rail Kits
Stair Rail Kits
Figure 10
Stair Rail Kit
Installation Instructions
[Continued]
1
2
"
Top
Figure 9
Figure 6
1
2
"
Figure 7
Figure 8
Top Rail
Upper
Bracket
Cover
Bottom
Rail Upper
Bracket
Cover
Bottom
Rail
Lower
Bracket
Cover
Top Rail
Lower
Bracket
Cover
of the bottom rail.
Step 7: Slide the bottom rail upper and lower bracket covers onto the respective
ends of the bottom rail. Position the rail so it can be attached to the mounting
brackets, making sure the rail sits on the resting flanges. Install two of the supplied
1" Phillips stainless steel pan head screws into each mounting bracket (1 on each
side) in the middle slot of the brackets. The screws should be located as close to
the radius end of the slot as possible, which is approximately
1
/
2
" from the end of
the rail. Note: If using a cordless drill, be careful not to strip the screws. Slide the
covers toward the post until they snap on to the mounting brackets. An audible
“click” should be heard, signifying that the covers are now secure (Figure 6).
Step 8: To determine the location of the top rail mounting brackets, insert two
spindles in the bottom rail, one at each end of the pre-cut holes. Slide a top
rail mounting bracket on each end of the top rail. The lower bracket should be
pushed up as far as possible on the rail end (bottom of rail should NOT be resting
on the resting flange) and the upper bracket should be positioned so that the
bottom of the rail is sitting on the resting flange. Place the top rail on the spindles,
inserting the two spindles into the respective pre-cut holes. Push down on the
top rail to make sure it is resting securely on top of the spindles. Before marking
the locations of the mounting brackets, make sure the spindles are plumb. Using
a pencil, mark the location of the mounting brackets so they can be attached
to the mounting surface. Remove the top rail, top rail mounting brackets, and
spindles, and then secure the brackets to the mounting surface using eight of
the 1
1
/
2
" Phillips stainless steel pan head screws supplied and the marks made
previously (Figure 7).
Step 9: Insert all of the spindles into the pre-cut holes in the bottom rail.
Step 10: Slide the top rail upper & lower bracket covers onto their respective
ends of the top rail. Place the top rail on the spindles, inserting the spindles one
at a time while holding the top rail at an upward angle. Once all of the spindles
are inserted into the top rail, it should be positioned so that it can be attached to
the top rail mounting brackets. Note: The upper end of the rail should be sitting
on the resting flange, but the lower end of the top rail should not (Figure 8 & 9).
Step 11: Install four of the supplied 1" long Phillips stainless steel pan head
screws into each mounting bracket (2 on each side) in the top and bottom slots of
the brackets. The screws should be located as close to the radius end of the slot
as possible, which is approximately
1
/
2
" from the end of the rail. Slide the covers
towards the mounting plates until they snap onto the mounting plates. An audible
“click” should be heard, signifying that the covers are now secure (Figure 10).
This completes the installation of your QuickRail Plus
®
Stair Rail Kit.
For use in applications less than 30" above ground.
QuickRail Plus Instructions I 4