Installation Instructions

Consumer Installation Sheet

PRE-INSTALLATION

INSTALLATION

Step 3 - Joints & Cuts.

When installing multiple rolls wall-to-wall, consumers can:

a. Overlap rolls (1½” to 6”)

—OR—

b. Butt Joints - Trim edges to continue floor pattern by forming a

tight butt joint between rolls. Follow guidelines for butt-type joints.

Step 2 - Unroll Floor.

Position G-Floor® at front of garage, one roll at a time. Roll ooring out

front to back and position carefully.

Use a broom to push out any air underneath G-Floor.

Step 1 - Clean Floor.

Make sure garage oor is clean, dry, and free of any objects. Sweep

dirt out of garage and remove any lumps or excess cement/debris that

might cause a bump on the surface.

Measure oor to order proper amount of ooring.

Measure the oor.

Roll out ooring front-to-back.

Clean oor before applying ooring.

Push out any air with a broom.

Overlap Joint Butt Joint

Butt-type seaming guidelines.

Fold back edge of roll #1 and wipe clean. Attach tape along roll #1’s

edge (leaving 2” of tape exposed) and fold back into position.

Fold back roll #2 and wipe bottom edge clean. Carefully align along

edge of roll #1. Do not stretch mat or tape when applying.

PAGE 1
Consumer Installation Sheet PRE-INSTALLATION Measure floor to order proper amount of flooring. Measure the floor. INSTALLATION Step 1 - Clean Floor. Make sure garage floor is clean, dry, and free of any objects. Sweep dirt out of garage and remove any lumps or excess cement/debris that might cause a bump on the surface. Clean floor before applying flooring. Step 2 - Unroll Floor. Position G-Floor® at front of garage, one roll at a time. Roll flooring out front to back and position carefully.
PAGE 2
Consumer Installation Sheet Butt-type seaming guidelines. Fold back edge of roll #1 and wipe clean. Attach tape along roll #1’s edge (leaving 2” of tape exposed) and fold back into position. Fold back roll #2 and wipe bottom edge clean. Carefully align along edge of roll #1. Do not stretch mat or tape when applying. Let G-Floor “float” between exterior walls to allow for expansion and contraction. NOTE: For custom fit, always allow product to relax in place before trimming around edges and corners.