User's Manual

For More Info : www.gg2002.com
CancelCancel
Cancel
Enter Bluetooth
Enter Bluetooth
Passkey:
Passkey:
Enter Bluetooth
Enter Bluetooth
Passkey:
Passkey:
0000
0000
0000
0000
What is IsolationMode™ ??
Indicate The Battery Status
90
IsolationMode™ is suitable for one person
usage. During IsolationMode™, sensitivity
of microphone is redirected to participant
within a 90 degree angle. Voice outside
the 90 degree angle will not be transmitted
over the other end.
Each time you pick up a call, your
Handsfree Kit is in IsolationMode™.
Short press the Volume Up Button and the
Volume Down Button at the same time
when your headset is in standby mode.
Red light flashes 5 time indicates that the
battery is full.
Red light flashes 4 time indicates that the
battery is 80% full.
Red light flashes 3 time indicates that the
battery is 60% full.
Red light flashes 2 time indicates that the
battery is 40% full.
Red light flashes 1 time indicates that the
battery is 20% full.
x 5
x 4
x 3
x 2
x 1
Redial A Call
Long press the Volume down button
when your Handsfree Kit is connected to
your Bluetooth mobile phone.
Increase / Decrease Volume
Press the Volume Up Button /
the Volume Down Button
repeatedly to increase or decrease
volume.
Reset The Device
Resetting the device means that all
the previously paired mobile phones
will be erased.
During standby mode, (Blue light
blinking 1 time every 4 seconds),
press all four buttons.
1.
Press the MFB I when
Handsfree kit is connected to the
phone.
Say the name of the person that
you wish to call after the”beep”.
2.
Voice Dial
Mute The Microphone
Answer / End A Phone Call
Press the MFB I to answer
incoming calls.
Press the MFB II to end or reject
a call.
When Handsfree Kit is in talking mode,
press the Volume Up Button and
the Volume Down Button together
once to mute the mic, press together
once again to unmute.
Turn On / Turn Off
Press the MFB II until Handsfree
Kit voice prompt “Hello” or “Goodbye”.
BluetoothHandsfreeKit
Pairing
Initial Test
Your Handsfree Kit and your device should now be paired and connected,
ready to make and receive calls. To confirm they are successfully paired
and operating properly please try the following.
Press Send on your phone to initial the call.
The call will be heard on the Handsfree Kit.
2.
On your phone’s keypad, dial a contact you wish to call.1.
If the Handsfree Kit does not enter into pairing mode automatically it could already
be paired with another phone and you have to perform a master reset. The Handsfree
Kit can only be paired with one phone at a time.After you have paired the Handsfree
Kit with the phone, it will automatically connect to the phone as soon as it is turned on
and within range.
Once pairing is successful, Handsfree Kit will
voice prompt ”Pairing Successful”.
4.
Enter the Pincode/ Passkey “0000”.3-4.
Note : After pairing, some devices will autimatically connect to your Handsfree Kit,
and some will not. You can manually select connection from your mobile phone.
Features
Audio Transfer
If you want to transfer your call to your
mobile phone while speaking on the
Handsfree Kit, tab on the MFB I
and you can continue your conversation
on the mobile phone.