User's Manual

G-scan2 User Manual
29
from AC outlet
1. Connect the DC jack of the AC/DC converter to G-scan2’s DC input jack.
2. Extend the AC plug of the AC/DC converter to the AC outlet.
3. Power is supplied to G-scan2
Caution
Make sure to use the AC/DC adapter that is supplied with G-scan2.
Damage caused from use of unapproved AC/DC adapter is not subject to warranty service.
Turning G-scan2 ON
Hold down the POWER button for about 0.5 seconds to turn the G-scan2 on.
The LED indicator illuminates in blue which goes off shortly after, then the G-scan2 booting
sequence is initiated. The booting sequence is followed by the main menu display.
Turning G-scan2 OFF
Hold down the POWER button for about 2 seconds to turn the G-scan2 off.
“The system is shutting down” message appears on the screen, the LED indicator shortly
illuminates in blue, then the G-scan2 is powered off completely.
Switching G-scan2 to Standby mode
A stand-by mode query pops up when the POWER button is pressed shortly as shown below:
Wait until the timer counts down to zero, then the G-scan2 switches to “Standby mode”. In
Standby mode, G-scan2 hibernates until any key is pressed. Upon any key stroke or a screen
touch, it resumes normal operation instantly without going through the boot-up sequence.
Select “Power OFF” to turn the G-scan2 off completely.
In case of unintended stroke of POWER button or pressed by accident, select “Cancel”.