User's Manual

G-scan2 User Manual
7
1.3. Safety Warnings and Cautions
Cautions and Warnings
AA-1-3. Safety Warnings and Cautions
This section contains warnings and cautions for safe and proper use of this product, therefore it is
recommended that every user should read this section carefully before using the product and make
sure that such warnings and precautions are well observed and comprehended.
 Use G-scan2 only for the original purposes as it was designed for.
 Keep G-scan2 within the specified storage temperature when not in use (See spec sheet)
 Place the G-scan2 at a secured location and keep clearance with any moving part of the vehicle or
hazardous environment when using G-scan2 with the vehicle.
 Use only the parts and accessories authorized by GIT.
 Do not disassemble or dismantle the G-scan2 base unit in any case.
Beware that only the service personnel authorized by GIT is entitled to provide after-sales service
for G-scan2.
 Supply stable power from the external source (using AC/DC adapter) when updating G-scan2
software (Operating System, Firmware and Application updates).
Use the power adapter and cables supplied by GIT only when supplying power from then external
source.
 Make secure connections of all cables and connectors. Be careful not to let the DLC cable or
power cable gets disconnected while the G-scan2 is operating.
 Observe the instructions of this user’s manual when replacing the rechargeable battery.
 Do not use the rechargeable battery other than GIT supplies.
 Do not disassemble the rechargeable battery in any case.
 Do not put the rechargeable battery in the water and keep away from moisture.
 Keep the rechargeable battery from the heat.
Warning
Dangerous consequences may arise, with the possibility of fire, death or serious injury to the user,
if the product is not handled properly as instructed below.
The user shall be fully liable for any direct or consequential damage or loss caused by not following
the instructions provided in this G-scan2 user’s manual.