User's Manual

G-scan2 User Manual
8
 Do not apply physical impact to the rechargeable battery or pierce with a sharp object.
 Do not put the rechargeable battery in the microwave oven or high-voltage container.
 In case any smell, heat, distortion or discoloration is observed with the rechargeable battery, stop
using it. If such a symptom is witnessed when charging or operating, remove the battery from
the base unit.
 Be careful not to put the rechargeable battery in reversed polarity.
 Do not short-circuit the rechargeable battery terminals.
 Do not connect the rechargeable battery terminals directly with the external power sources.
 Do not put the rechargeable battery in fire or expose it to direct sun light.
 Put G-scan2 base unit on a secure place and avoid unstable, inclined or slippery place.
Be careful not to drop the G-scan2 base unit.
 Avoid humidity and dusts when storing and using G-scan2 in order to prevent electric shock or
fire.
 Do not put heavy objects such as hand tools on the G-scan2 base unit.
 Stow the parts and accessories that are not in use in the G-scan2 carry case.
 Avoid following hazards for storing G-scan2.
- Too high or low temperature (See Spec sheet)
- Too high or low humidity (See Spec sheet)
- Exposure to direct sunlight
 Be careful not to cause damages to the cables by heat from the engine or the moving parts in the
engine compartment when G-scan2 cable connection is made under the hood.
 Securely tighten the screw lockers when connecting the DLC main cable to the G-scan2 base unit.
 When supplying power from the vehicle battery, check the connection for correct polarity.
 Do not carry the G-scan2 by holding the cables connected to the base unit.
 Avoid physical impart and vibration when carrying G-scan2.
Caution
Dangerous consequences may arise, with the possibility of serious injury to the user and or
damage to the product, if the equipment is not handheld correctly as instructed below.
The user shall be fully liable for any direct or consequential damage or loss caused by not
following the instructions provided in this G-scan2 user’s manual.