User's Manual

User’s Manual
- 40 -
Vehicle with the OBD-II Standard Connector
Only with the DLC COM cable without additional power line, it is possible
to communicate with control module and to supply power.
Tips
In general, the DLC connector is located at the lower part of the driver’s
front panel. According to the kinds of vehicle, it may be different.
Therefore, before connecting, please check the correct position at first.
Vehicle without the OBD-II Standard Connector
Connecting the power
For the vehicle without the OBD-II standard connector, connect the
power line additionally for operating the G-scan
Connecting the vehicle diagnosis
For the communication with the control module installed at the vehicle,
additional adapter is required. After connecting the adapter to the 16
th
pin of the DLC cable, connect it to the COM connector terminal of the
vehicle.
Notice:
For the power supplying, refer to “Power Supplying”<A-02-001> in the
“Basic Use of G-scan”.