User's Manual

User’s Manual
- 75 -
System Selection using touch screen
z The system selection order and cautions using the touch screen are
the same with them using the H/W button described above. Using the
stylus pen, select wanted items on the touch screen.
z When the wanted items are not shown in each zone, move the scroll
bar up and down to find the items.
z To delete the registered system in the “Selected” zone, select the
system in the “Selected” zone again and then press the
or
button.
Note:
 The system selection setup finally by user is not deleted even the
power is OFF. When the
is selected, the previous setup
will be applied again.

 .
Multiple System Selection
The multiple of control modules registered in the “Selected” will shows
all fault codes saved in the control modules to be diagnosed in one
screen by just one function selection using the .
Select all control modules which may have problems in the vehicle.
However, it is not supported to the vehicle applied with special protocol
type communication method.